ExacqVision: Integrating an AV20CPD-118 using ONVIF

Objective

Successfully connect the camera to the server with a password and enable motion recording. 

Solution 

• Ensure both the camera and Exacq software are on current software revisions.
• Add the camera as an ONVIF device if you want to use a password and record on motion.
• The camera will not connect with the AV driver if a password is configured on the camera.  

General Setup:

1. Click Config > Systems > exacqVision Server > Configure System > Add IP Cameras.
2. Click New.
3. Next to Device Type select ONVIF.
4. Provide the IP Address of the camera then click Apply.
5. Once the camera is added click the Live Page.
6. You will see 4 inputs from the camera populated.

 Motion Recording:

1. Delete the camera from Exacq.
2. Navigate to the webpage of the camera and set a password.
3. Enable motion detection and validate it's triggering properly.
4. Add the camera using ONVIF as described above but include the username/password specified.
5. Verify motion is triggering in Exacq.