How to install the MD-JBA with a MegaDome G3 series camera.

Issue:

An installer needs the proper installation steps for the MD-JBA.

Resolution:

1. Remove the magnetic mounting plate from the bottom of the MegaDome G3.
   
   
   
   
2. Position the mounting plate onto the MD-JBA, aligning the set of holes labeled "A".
   
   
   
   
3. Install the rubber grommet for the Ethernet cable. Align the hole with the camera and mounting plate.
   
   
   
   
4. Attach the camera onto the mounting plate.
   
   
   
   
5. The area where the mounting plate and the MD-JBA meet can be a weak point in the mount. Be sure to seal this with a sealant like silicon if water is a hazard.
   
   
   
   
6. Tighten the 4 screws located on the camera body to affix it to the MD-JBA.